skinnygasra.blogg.se - Configure cisco virtual wireless lan controller to layer 3

#Configure cisco virtual wireless lan controller to layer 3 software#
#Configure cisco virtual wireless lan controller to layer 3 mac#

You must not configure a dynamic interface in the same network as that of Local Mobility Anchor (LMA). Interfaces must be on a different IP subnet from any other interface configured on the port.įor information about maximum number of VLANs supported on a controller platform, see the respective controller platform's Must be on a different VLAN or IP subnet from all other interfaces configured on the port. You can configure zero, one, or multiple dynamic interfaces on a distribution system port. If management by dynamic interface option is enabled. Management traffic such as Telnet or SSH, HTTP or HTTPS, and so on, can use a dynamic interface as their destination address Management interface, and the Layer 3 AP-manager interface, and you can map the dynamic interface to a backup port. You can assign dynamic interfaces to distribution system ports, WLANs, the Layer 2 Alternatively,Ī dynamic interface can also be configured as an AP management interface as well, in place of the default management interface The dynamic interface will also be the interface through which network communication to andįrom the controller will occur if the destination address is in the same subnet assigned to a dynamic interface. If DHCP relay is enabled on the controller, then the applicable dynamic interface A dynamic interface is a Layer 3 interface on the controller to mapĪ WLAN to a particular VLAN and subnet. Each dynamic interface is individually configured and allows separate communication streams to exist onĪny or all of a controller’s distribution system ports. A controller can support up to 512 dynamic In a LAG setup, theĭynamic interface on a controller is conceptually analogous to an SVI on a switch or router associated with a single VLANĪnd single subnet, although the controller does not have any routing capabilities.

Restrictions for Configuring Dynamic Interfacesĭynamic interfaces are created by users and designed to be analogous to VLANs for wireless LAN clients.

Prerequisites for Configuring Dynamic Interfaces.

Configuring Dynamic Anchoring for Clients with Static IP Addresses.

Validating WLAN Mobility Security Values.

Configuring AAA Overrides for FlexConnect.

Configuring a Spectrum Expert Connection.

Configuring CCX Radio Management Features.

Configuring RRM Neighbor Discovery Packets.

Configuring Access Points with Dual-Band Radios.

Configuring LED States for Access Points.

Retrieving the Unique Device Identifier on Controllers and Access Points.

Optimizing RFID Tracking on Access Points.

Configuring Access Point Retransmission Interval and Retry Count.

Configuring Failover Priority for Access Points.

Converting Autonomous Access Points to Lightweight Mode.

Configuring Authentication for Access Points.

Configuring Global Credentials for Access Points.

Configuring Per-WLAN RADIUS Source Support.

Configuring NAC Out-of-Band Integration.

Configuring Web Redirect with 8021.X Authentication.

Configuring Reanchoring of Roaming Voice Clients.

Configuring Key Telephone System-Based CAC.Configuring Media Session Snooping and Reporting.

#Configure cisco virtual wireless lan controller to layer 3 mac#

Configuring a Fallback Policy with MAC Filtering and Web Authentication.

Configuring Cisco Intrusion Detection System.

Configuring Management Frame Protection.

Configuring and Applying Access Control Lists.

Using Dynamic Interfaces for Management.

Configuring the System for SpectraLink NetLink Telephones.

Configuring Local Network Users on the Controller.

Configuring Maximum Local Database Entries.

Cisco Unified Wireless Network Solution Security.

Configuring Multiple AP-Manager Interfaces.

#Configure cisco virtual wireless lan controller to layer 3 software#

Managing Controller Software and Configurations.Resetting the Controller to Default Settings.Configuring the Cisco Discovery ProtocolĪuthentication for the Controller and NTP/SNTP Server.Configuring Application Visibility and Control.